Description
The LRP suspension spacer kit is made for Land Rover Discovery 3, Discovery 4 and Range Rover Sport L320, it is recommended for all those who need keep raised the vehicle.
The LRP suspension spacer kit are suitable both for vehicles with air suspension and for vehicles with coil suspensions (factory or converted).
In vehicles equipped with air suspension, the spacers do not raise the vehicle because the height is always determined by the corner sensors of the pneumatic system. In order to raise the vehicle, they must be deceived by installing the Lift Rods (+2.5 “) or our Easy Lift suspension module (set to + 55mm). These devices will determine the final height of the vehicle.
The advantages of the installation on Pneumatic Suspensions, extremely recommended for those who fit larger tires are:
- Continue driving even in an emergency! Thanks to the LRP suspension spacers, if the car lowers on the pads due to a fault, the body will not rest on the tires
- Despite the lift, having the same amount of air inside the air suspension as you would at standard height.
NOTE: with this kit installed will not be possible to lower the car to Access Height because the car will be raised in extended mode
If the vehicle is equipped with traditional coil spring suspensions (from factory or converted), the LRP suspensions provide to rise +50mm (+2″) the vehicle.
To reach the main goal of treatment against corrosion, the LRP suspension spacers, before being powder coated, are subjected to a primer painting by cataphoresis process.
LRP Suspension spacers are supplied in 3 different kits, suitable for every need:
| Kit | Contents | Lift |
|---|---|---|
| Full | 4 x spacers 50mm (2″) 12 x self-locking nuts 4 x airline extensions 1 x 2,5″ LRP Lift Rods kit | +2.5" |
| Basic | 4 x spacers 50mm (2″) 12 x self-locking nuts 4 x airline extensions | Related to your Lift Rods installed or, if equipped with our Easy Lift control unit, this MUST be constantly set a minimum height of +55mm |
| Coils spring suspensions | 4 x spacers 50mm (2″) 12 x self-locking nuts | +50mm (+2") |
